Gas Pressure too high Error
This problem may be seen if a Gas regulator has been dropped or knocked, the preset of the regulator can be moved slightly to cause this error message. To correct this problem it is necessary to remove the security cap on the front of the regulator to reveal the Hexagonal key bolt underneath. This will require a Hex Key size 6.0mm this will need to be turned slightly anticlockwise to reduce the Gas outlet pressure of the regulator. Move one quarter turn and then retest gas calibration. If Calibration is successful replace brass cover cap. If not successful, repeat step 1 until calibration passes.
Gas Pressure too low error
As with the above error, this can be caused by disturbance of the Regulator Output Pressure Adjuster. Remove the brass cap covering the adjuster, and turn the adjuster CLOCKWISE one quarter turn.
Perform another Gas Calibration after each adjustment & repeat process until Gas Calibration passes. Replace brass cap securely, being careful not to move the adjuster while doing so.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article